Some matters needing attention when you are using bucket teeth

- Aug 01, 2018 -

400_400.jpg1. the bucket teeth should be sharp.           

2. bucket teeth on both sides are generally faster than the bucket teeth in the middle of the bucket. When the bucket teeth on both sides are worn much shorter than the middle bucket teeth, the middle and two sides of the bucket teeth can be swapped to continue to use. If the difference between the center part of bucket teeth and the two ends of bucket teeth is 2~3 cm, they should be replaced.            

3. if the difference between the center part of bucket teeth and the two end bucket teeth is 2~3 cm, they should be replaced. Please replace the bucket in time.            

4. visually check the loosening and wear of bucket teeth before operation everyday. If the wear of the bucket teeth exceeds the limit of use, it will not only damage the gear base and bucket, but also affect the efficiency of excavation and reduce the output.

 

What will be the rippers used for?

Excavator looser is a excavator with pine soil and bulldozer, the excavator is also called a bulldozer, and the excavator is also called the bucket hook. The bulldozer is also called the tail hook. It is usually single tooth, and also has two teeth or three teeth, and the excavation force is strong. It is suitable for crushing and splitting hard soil, secondary hard rock and wind fossils so as to facilitate digging and loading operations with excavating bucket.