Bucket reinforcement technology has been done in place three years do not need to renew!
Bucket and bucket teeth are vulnerable parts are not surprising to everyone, usually less than scrap, we will choose to reinforce the bucket by welding and other means, seldom choose to replace directly.
On the one hand, it can save money and cost, on the other hand, it can save a lot of time in the case of urgent engineering work. But in fact, there are many skills to reinforce the bucket. The following is a detailed introduction.
The importance of tooth root reinforcement is believed to be in everyone's mind, after all, the excavator tooth root is not solid, wear will increase with each passing day, in the long run may even bucket tooth installation will be extremely difficult.
Generally speaking, the old driver will take the following two ways to reinforce the root of the tooth. The first way is to stick the reinforcement bar directly, and the other way is to wrap the wear-resistant block directly.
Bucket floor reinforcement，Usually people will choose hard, wear-resistant raw materials as bucket bottom reinforcement materials, for example, many people choose the chain board is better, of course, in the welding should also pay attention to the protection of the bucket's overall shape, welding direction, angle, etc.
The reinforcement method of edge plate is relatively simple, it is necessary to pay attention to the installation of edge knife. On the one hand, the installation of edge knife can cut into the material more smoothly, on the other hand, it also plays a role in protecting the edge plate.